Search results

It should not affect the engine temperature as it is only the same as when the tank is hot and no longer takes any heat from the engine.

I would be more concerned about what appears to be quite a sharp transition between the hub and the blades. This would create a stress raiser at the point at which the blade appears to have initiated a crack. A larger radius at the junction would have reduced this effect.

What you need is a car overdrive solenoid, they switch to a light holding coil once engaged.

What about leaving the existing nuts and bolts in place and drilling additional holes through the hull and plate and then installing new nuts and bolts.

Hi, One thing did occur to me, when you say it turns over with a spanner, how far did you rotate it? Is it possible that it has water/fuel in a cylinder and is hydraulically locked.

If your engine is below the waterline or, more precisely, the water injection point into the exhaust is then, as I found on a previous boat, the only thing between a flooded engine (or boat) is the impeller in the pump. This can be alleviated by installing a syphon break however they can be...

I once had a car that periodically did this. After much investigation I found that a diode in the alternator was breaking down and discharging the battery. I happened to notice the alternator was hot (really hot) at the same time as the battery was flat. Luckily it was one of the last cars with...

I was there at the weekend and can confirm that is the case.

SOLD Winches now sold - thank-you.

FullCircle, Thank-you for supporting my original post. I can confirm that the liferaft is NOT for sale on Ebay. The price is offers BELOW £400. As I have no idea what the liferaft is worth, I am sure the price will be set by what someone is prepared to pay - hence the "open to offers"...

I have an XM 4 man cannister liferaft for sale. I bought it from new in approximately 2010/2011 and it has never been used!! Similar (but newer) models can be seen on the Marine Megastore and Jimmy Green websites for £700 - £800. This will need a service - a rough estimate from google is £100...

Ash, They are about 76 mm diameter at the drum and 140 mm high. The base measures 150 mm across. Hope this helps - let me know if you require any other measurements. Regards, Barry

I have a pair of Gibb 40RA winches for sale in good condition. They are very slightly different in shade as can be seen in the picture but I never noticed when they were on the boat - only when I photographed them! Due to weight, collection would be preferred (Cornwall) - I do regularly travel...

Now sold

Bow fitting photo Picture attached. Barry

Self stowing/launching anchor fitting for 15 to 20 kg anchor. Stainless steel with tilting aluminium chute. 500 mm long and 55 mm wide chute. Photo available on request. Located near Hayle in Cornwall - could pack if you want to arrange courier pick up. £50

I am so glad that I asked the question on here as I am getting the honest replies that I needed. Most of the photos are dated - the "bandage" on the shaft is masking tape!! - and are pre/during work. Rather stupidly, I had no idea that you could enlarge the photos and can now see that a new...

Thank you for your comments thus far, they have all been extremely constructive - I can now see the boat as others would see it. I will make appropriate amendments. Thanks again, Barry