[2574]
...
This is a long shot - does anyone on here have a Flexofold propellor puller tool that I could borrow or buy? I can get one shipped from Denmark but that'll take time, if there was one in the UK that would be extremely handy.
Flexofold puller please?
- Thread starter [2574]
- Start date
DinghyMan
Well-known member
2 or 3 bladed?
I think the smaller GORI style prop removers will also work for FlexoFold, same idea of put them under the pins and use a central bolt to remove the prop
Measurements I have for FlexoFold is 30mm wide bar and "wings" which is same width as GORI removers
Alternative is a piece of 30mm x 20mm bar with a threaded hole through it
I think the smaller GORI style prop removers will also work for FlexoFold, same idea of put them under the pins and use a central bolt to remove the prop
Measurements I have for FlexoFold is 30mm wide bar and "wings" which is same width as GORI removers
Alternative is a piece of 30mm x 20mm bar with a threaded hole through it
[2574]
...
Three blade with 30mm wide blade root. Didn’t know the Gori puller would fit.
DinghyMan
Well-known member
Volvo 3 bladed puller - got a flatter version of the above, central hub is 45mm wide, wings are 25mm wide by 15mm thick, central 16mm HT bolt
[2574]
...
Ooooh.....that might work. Will send pm later.
MAURICE
Active member
interested in this as I had a heck of a job getting mine off. I had to use some heat a hammer and a puller that didn't quite fit
DinghyMan
Well-known member
The Volvo type puller above should work with the Flexofold props as the legs should fit between the hub and the retaining pins, just like the genuine puller
